HexViewer: Export Bin Įxports the current hex view to a binary file. If at any time you would like to discard all of the changes you have currently made to the hex view, you can invoke this command and a clean hex view will be reloaded. Strings can also be used by using the s: prefix followed by the equivalent ASCII characters that are to replace the selected bytes. They can then be modified and submitted to replace the original bytes. Invoking this command will take the currently selected bytes on a line and display them in an input panel. Input is received through the input panel. Moves the cursor to the given offset (address). HexViewer: Set Bytes Per Line Īllows selection from the quick panel the number of bytes to be shown on a line (allowed options are defined in valid_bytes_per_line). All edits will be lost, so export your changes before you do this. This will reload the file with this formatting. HexViewer: Set Bits Per Group Īllows selection from the quick panel the grouping of bytes by 8, 16, 32, 64, and 128 bits. Toggles the parsing of bytes to big or little endian when showing unit types in Hex Inspector. ![]() HexViewer: Toggle Endiannes (Big|Little) The Hex Inspector is a panel which shows the current selected byte as different unit types. Below outlines what the commands are and what they do. There are various commands available via the command palette or by key-bindings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |